■ 16
│
GB
│
IE
SKHO 50 B2
The following table helps to identify and rectify further possible faults:
Fault Possible cause Remedy
The head-
phones cannot
be switched on.
The internal battery is
not charged.
Charge the battery (see section Charging the
battery).
No sound.
The headphones are
not switched on.
Press the button
4
for about 2 seconds
to switch on the headphones.
The volume is set to
minimum.
Set the desired volume using the
button 3. If necessary, also increase the
volume on the playback device.
The playback device
is not switched on.
Switch on the playback device.
The playback device
has been muted.
Unmute the playback device.
The audio cable w is
incorrectly connected
in AUX-IN mode.
Make sure that the audio cable w is correctly
connected to the AUX IN socket 8 of the
headphones and the playback device.
Sound is only
coming from
one side of the
headphones.
The stereo balance
control on the
playback device is
incorrectly adjusted.
Adjust the stereo balance control to the setting
you desire.
NOTE
► If you cannot solve the problem with the solutions given above, please contact the
Service Hotline (see section Service).
To Next Page
Loading...
