Silvercrest SLB 20 A1 - Checking the charge level; Operation and use; Switching the speaker on;off

SLB 20 A1
■ 70
│
GB
│
MT
Checking the charge level
You can also check the speaker's charge
level when it is not charged or while it is
being used for charging.
♦ While the device is switched on, briefly
press any
button. The four LEDs of the
battery charge level display 1 show
the current charge level of the speaker
for about 10 seconds.
NOTE
► For information about checking the
speaker’s approximate charge level
using the
battery charge level
display
1, refer to the table in the
section Charging the internal battery.
Operation and use
Switching the speaker on/off
♦ Press and hold the button 2 for
about 3 seconds to switch the speaker
on and activate the Bluetooth
®
func-
tion. The button 2 flashes orange
twice and you will hear a beep.
IB_341802_SLB20A1_LB5.indb 70 19.05.2020 15:14:40