SLB 20 A1
■ 82
│
GB
│
MT
♦ Press the button 7 on the first
speaker (which will function as the left
speaker) for about 3 seconds. You will
hear a beep and the TWS LED 8
flashes green during the pairing.
♦ If the pairing of the two speakers has
been successful, you will hear a short
beep. TWS mode is active and the
TWS LEDs
8 on both speakers
light up green.
♦ Pair the left speaker with an external
Bluetooth
®
device.
♦ Start playback on the external
Bluetooth
®
device.
NOTE
► If you do not pair the two speakers
within 3 minutes, the speakers will turn
off automatically. In this case, you will
have to switch the speakers back on
again before restarting the pairing
process.
► Make sure you position the left and
right speakers correctly for playback.
► The Play/Pause/Forward/Back/Bass-
Boost buttons work on both speakers in
TWS mode.
IB_341802_SLB20A1_LB5.indb 82 19.05.2020 15:14:40
To Next Page
Loading...
