Silvercrest SLE 420 A1 - Displays; Modes of Operation

8
GB
Air outlet flap valve
Figure B: irrespective of which mode the
device is being operated in, open the top
flap valve 1. It clicks into place in four posi-
tions.
If the flap valve is not opened, the overheat-
ing protection will switch the device off after
a while for approx. 3 minutes.
7.2 Displays
The mode of operation LEDs 14 and the dis-
play 13 show the selected functions and the
humidity range.
Mode of operation LEDs
Display
7.3 Modes of operation
NOTE: the values selected for relative hu-
midity (RH%) are recognised with an up-
wards or downwards deviation of approx.
3%. This is necessary so that the device does
not constantly switch on and off.
• The device has 4 different modes avail-
able.
• By pressing the button 17 MODE, you
can switch between the modes.
• The mode of operation LED 14 next to
the active mode illuminates.
AUTOMATIC
The setting for the target relative humidity
(RH) is fixed at 55%. The compressor dehu-
midifies until this value has been reached,
and will then switch off. When the relative
humidity rises again, the compressor switch-
es on again.
In this mode, the device operates in 3 differ-
ent stages:
- RH over 70%: the device dehumidifies
at its highest setting.
LED illuminated Meaning
TANK FULL
The water tank is
full or has not been
inserted.
TIMER
A switch-off time is
activated.
AIR CLEAN
DRY CLOTHES
CONTINUOUS
AUTOMATIC
Selected mode
OPERATION
The device is
switched on.
Display Meaning
This display can be seen
continuously during oper-
ation. It shows the humid-
ity range in the room:
LOW: under 65%
MID: 65% to 75%
HIGH: over 75%
MID.
LOW
HIGH
MID.
LOW
HIGH
MID.
LOW
HIGH
1 - 12
flash for 5 sec.
Timer for all modes:
These values (1 - 12 hours)
will flash for 5 seconds
when you use the arrow
keys to select a switch-off
time.
30 - 80 or CO
flash for 5 sec.
Set relative humidity in
continuous operation.
Values between 30 and
80 or CO will flash for
5seconds when
selected.
CO: The device dehu-
midifies continuously.
Display Meaning
__RP89301_B4.book Seite 8 Freitag, 19. April 2013 7:28 19