EasyManua.ls Logo

Silvercrest SLE 420 A1 - Protection against Overheating; Storage; Trouble-Shooting

Silvercrest SLE 420 A1
100 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11
GB
11. Protection against
overheating
The device has an overheating protection
system.
The overheating protection system will
switch the device off automatically if
there is a risk of overheating.
It is then impossible to switch the device
on again for 3 minutes.
After approx. 3 minutes, the device
starts automatically.
Check whether external conditions
could have triggered the overheating
protection system, e.g. temperature
above 35 °C or a closed flap valve 1
over the air outlet.
12. Storage
DANGER for children! Keep the
device out of the reach of children.
Always store the device in an upright
position.
Select a location where neither high
temperatures nor moisture can affect the
device.
13. Trouble-shooting
If your device fails to function as required,
please try this checklist first. Perhaps there is
only a minor problem, and you can solve it
yourself.
DANGER! Risk of electric
shock! Do not attempt to repair
the device yourself under any cir-
cumstances.
Fault Possible causes/Action
No function.
Has the device been
connected to the power
supply?
Check the water level in
the water tank 5.
Check the position of
the water tank.
The overheating protec-
tion system has
switched the device off.
Wait for approx. 3 min-
utes.
The dehumid-
ification
does not
seem to be
working very
well.
Are the filters 24, 25
dirty?
Is the air inlet 8
blocked?
The temperature is low.
Is the device operating
in AIR CLEAN mode?
No dehumidification
takes place with this
program.
Is a window open, or
has steam been generat-
ed in the room?
Excessive
noise.
Is the device standing
on a level, solid sur-
face?
Occasion-
ally the
device stops
working.
Room temperature
above 35°C?
Room temperature be-
low 5°C?
Defrosting mode is ac-
tive.
Damp cloth-
ing is not
drying, or is
only drying
very slowly.
Is the air flow from the
device directly pointed
at the damp clothing?
Is the room temperature
too low?
__RP89301_B4.book Seite 11 Freitag, 19. April 2013 7:28 19

Table of Contents

Related product manuals