Attaching the presser foot holder
Getting ready
Important:
1. Install the presser foot holder
2. Inserting the presser foot
3. Removing the presser foot
4. Inserting the edge/ quilt guide (p).
Turn the main switch (19) to off ("O")
when carrying out all the operations!
Raise the presser bar (A) by lifting the
two-step presser foot lifter (17) Attach
the presser foot holder (B) as illustrated.
Lower the presser foot bar (B) until the
groove (C) is directly above the pin (D).
Lower the presser foot bar (A) as far as it
will go. The presser foot (a) will engage
automatically.
Raise the presser foot.
Press the lever (E) gently towards the
front and the presser foot disengages.
As shown in the illustration carefully
insert the edge/ quilt guide (p) e.g. For
hems, pleats, etc.
When sewing thick fabrics, the passage of
fabrics under the presser foot can be
improved by raising the two-step presser
foot lifter (17) further (arrow).
Two-step presser foot lifter
34
GB / IE
C
D
E
a
E
p
B
A
12
3
4
To Next Page
Loading...
