Silvercrest SRD F1 B1 - Recalling a Preset Station; Sleep Timer; Time Setting; Alarm Setting

16 GB
 Recalling a preset station
 You can recall a previously saved station by pressing PRESET/SET TIME [].
 Press TUNE– [] or TUNE+ [] to select the desired station memory.
 Press SELECT/SCAN [] to confirm.
NOTE: Preset Empty is displayed if the preset number is unoccupied.
 Sleep timer
In operation mode:
 Press SNOOZE/SLEEP[6] repeatedly to choose the sleep time:
Sleep off/10/20/30/60/70/80/90 minutes.
 When the sleep timer is activated, the sleep timer icon ( ) appears in the display.
 Checking the remaining sleep time: During counting down, press SNOOZE/SLEEP [6].
The interval remaining is shown in the display.
 Cancelling the sleep timer: Press SNOOZE/SLEEP [6] repeatedly until <Sleep off>
appears in the display.
 Time setting
 In standby mode, press and hold PRESET/SET TIME [] for 2 seconds to set the time
and date.
 Hour flashes. Press TUNE– [] or TUNE+ [] to set the desired hours. Press SELECT/
SCAN [] to confirm.
 Minute flashes. Press TUNE– [] or TUNE+ [] to set the desired minutes. Press
SELECT/SCAN [] to confirm.
 Date flashes. Press TUNE– [] or TUNE+ [] to set the desired date. Press SELECT/
SCAN to confirm.
 Month flashes. Press TUNE– [] or TUNE+ [] to set the desired month. Press SELECT/
SCAN [] to confirm.
 Year flashes. Press TUNE– [] or TUNE+ [] to set the desired year. Press SELECT/
SCAN [] to confirm.
 When the time is successfully set, <Time Saved> appears in the display.
 Alarm setting
 During operation, press and hold MENU/INFO [8] for 2 seconds to open the menu.
 Press TUNE– [] or TUNE+ [] to select <SYSTEM>. Press SELECT/SCAN [] to
confirm.
 Press TUNE– [] or TUNE+ [] to select <Alarm>. Press SELECT/SCAN [] to
confirm.
 Display: <AL 1>. Press TUNE– [] or TUNE+ [] to select <AL 1> or <AL 2>. Press
SELECT/SCAN [] to confirm.
 Display: <On time 00:00>. The hour flashes. Press TUNE– [] or TUNE+ [] to set the
desired hours. Press SELECT/SCAN [] to confirm.
 Display: <On time 00:00>. The minutes flash. Press TUNE– [] or TUNE+ [] to set
the desired minutes. Press SELECT/SCAN [] to confirm.
 Display: <Duration 60>. The numbers flash (minutes). Press TUNE–[] or TUNE+[]
to set the alarm duration (options: 15/30/45/60/90/120 minutes). Press SELECT/
SCAN [] to confirm.