Silvercrest SRD F1 B1 - Checking Alarm Time;Quick Alarm Setting; Snooze Function; Adjusting the Brightness of Display; Charging an External USB Device

17GB
 Display: <Source Buzzer/DAB/FM>. The source flashes. Press TUNE– [] or
TUNE+[] to set the alarm sound <Options: Buzzer/DAB/FM>. Press SELECT/
SCAN[] to confirm.
NOTE: If the alarm source is set to <DAB> or <FM>, set the option <LastListened>
(the last listened station) or the desired number of the preset station (for those stations that
are stored on presets 1 to 10) by pressing TUNE– [] or TUNE+[]. Press SELECT/
SCAN[] to confirm.
 Display <Daily, Once, weekends or weekdays> flashes. Press TUNE– []
or TUNE+ [] to set the alarm repetition (Options : Daily, Once, weekends or
weekdays). Press SELECT/SCAN [] to confirm.
NOTE: If the alarm is set to <Once>, select the date by pressing TUNE– [] or
TUNE+[]. Press SELECT/SCAN [] to confirm.
 Press TUNE– [] or TUNE+ [] to set the volume of the alarm. Press SELECT/SCAN []
to confirm.
 Display <Alarm off> flashes. Press TUNE– [] or TUNE+ [] to set <Alarm off> or
<Alarm on>. Press SELECT/SCAN [] to confirm.
 When the alarm is successfully set, <Alarm Saved> appears in the display.
NOTES:
 When the alarm sounds, press [7] or ALARM [9] to turn the alarm off.
 When Alarm 1 sounds, flashes in the display [1].
 When Alarm 2 sounds, flashes in the display [1].
 The volume gradually increases.
 After the alarm duration has elapsed, the product will return to standby mode
automatically.
 <FM> or <DAB> alarm: When the alarm sounds, the radio station appears in the
display[1].
 Checking alarm time/Quick alarm setting
 Press ALARM [9] to check the Alarm 1 and Alarm 2 time respectively.
 At Alarm 1 display, press and hold ALARM [9] to set Alarm 1.
 At Alarm 2 display, press and hold ALARM [9] to set Alarm 2.
 Snooze function
 In ON mode, press SNOOZE/SLEEP [6] while the alarm is ringing. The alarm
reactivates after approx. 10 minutes. The remaining snooze time is shown in the
display[1].
 Adjusting the brightness of display
 Press Dimmer [] to set the brightness of the display (Lo/Med/Hi).
 Charging an external USB device
 Connect a USB cable (not included) to the USB port[2].
 Connect the other end of the USB cable to your USB device. The rechargeable battery of
your USB device is charged automatically.
 Disconnect the USB cable from the USB port[2], when you want to stop charging.