Silvercrest SSJ 300 B3 - Controls, Reverse Mode, and Blockages; Preparing Sorbet

38
GB
9.4 Switching on/off and
reverse mode
• To turn on the device, set the on/off
switch12 to 1.
• To turn off the device, set the on/off
switch12 to 0.
• If you set the on/off switch12 to R, you
will start reverse mode. With this func-
tion you can eliminate small blockages.
9.5 Removing blockages
If a piece of fruit or vegetable is blocking the
auger5, it must be removed immediately.
You can recognise a blockage...
… if no more juice comes out of the
juice outlet9, even though pieces of
food are still in the food chute3.
… if the pieces of food in the food
chute3 no longer slide down,
… if there are unusual sounds, or
… if the motor becomes audibly slower.
Reverse mode
First, try to fix the blockage by using reverse
mode:
1. Set the on/off switch12 in sequence
to 0, for approx. 2 seconds to R (re-
verse mode) and again to 0.
2.
Turn the on/off switch 12 to 1 . Check
whether the device is working normally.
3. Repeat the process, if necessary.
Cleaning the device
If this does not resolve the blockage, follow
these steps:
1. Pull out the mains plug11.
2. Take the device apart (see “Disassem-
bly” on page 38).
3. Clean the auger5, the holder7, the
screen assembly6 and the working
container8 (see “Cleaning” on
page 39).
4. Reassemble the parts and proceed with
juice extraction.
10. Preparing a sorbet
WARNING! Risk of material dam-
age!
~ The device is designed to prepare sor-
bet for up to 5 minutes maximum oper-
ating time without interruption. After
this, the device must remain switched off
until the base unit13 has completely
cooled down.
1. Assemble the device for sorbet prepa-
ration (see “Insert the sorbet assembly”
on page 35).
2. Prepare half frozen fruit pieces (see
“Preparing food for sorbet prepara-
tion” on page 36).
3. Proceed in the same way as for juicing.
The finished sorbet is ejected through
the juice outlet9.
4. Mix the sorbet again with a spoon and
serve it immediately.
11. Disassembly
DANGER! Risk of electric
shock!
~ Pull the mains plug11 out of the wall
socket before you disassemble and
clean the device.
1. Pull the food pusher1 off upwards
from the food chute3.
2. Remove the filling aid2.
3. Turn the lid4 anticlockwise until
the pointsymbol
• points to the
opened lock symbol . Remove the
lid4.
4. Close the drip stopper10.
5. Pull out upwards the screen assembly6 /
sorbet assembly19 complete with the
auger5. While doing this, move these
parts somewhat back and forth to
make them easier to release.
GB_352263_2007.fm Seite 38 Dienstag, 8. Dezember 2020 11:02 11