Silvercrest SSMM 600 A1 - Whisk Operation; Masher Operation; Chopper Operation

11
GB
6.4 Whisk
Application area:
The whisk is suitable for beating whipped
cream (max. 300 ml), egg whites (max. 4)
and food of a similarly light consistency.
1. Put the cream, egg whites or similar
into the measuring beaker|21 or anoth-
er suitable container.
2. Immerse the whisk|6 into the cream or
similar.
3. Connect the mains plug|3 with the wall
socket.
4. Press the controller|2 to switch the de-
vice on and release it to switch off.
5. After whipping remove the mains plug| 3
and take the whisk|
6 out of the food.
6. Remove the whisk|6 from the whisk
adapter|5.
7. Clean the device immediately if possible.
6.5 Masher
Application area:
The masher|23 is suited to mash cooked
fruit or vegetables such as apples, plums,
potatoes or sweet potatoes.
1. Fill food into a suitable container.
2. Place the motor unit|1 on the mash-
er|23 until it engages.
3. Immerse the masher|23 into the food to
be pureed/blended.
4. Connect the mains plug|3 with the wall
socket.
5. Press the controller|2 to switch the de-
vice on. The speed increases with the
intensity the controller is pressed.
6. Move the hand masher|23 up and
down a bit in the food, to ensure that it
is blended evenly.
7. When you are finished, let go of the
controller|2.
8. After the mixing process, wait until the
blade comes to a standstill. Pull out the
mains plug|3 and take the masher|23
out of the food.
9. Clean the device immediately if possible.
6.6 Chopper
Application area:
The chopper is ideal for chopping meat, Par-
mesan, vegetables, fruit, nuts and herbs.
Preparing food:
• Rinse or wash the food.
• Cut the food up into smaller pieces.
• Remove the outer shell from nuts. You
may use the inner skin if you wish, e.g.
with almonds.
• Use fresh herbs without stems and in a
dry condition.
• Remove sinews, bones and gristle from
the meat.
1. Fill the food into the container|26 with
blade assembly|27 and close it with
the drive cover|28.
2. Place the motor unit|1 onto the drive
cover|28 until it engages.
3. Connect the mains plug|3 with the wall
socket.
4. Press the controller|2 to switch the de-
vice on and release it to switch off.
5. After chopping remove the mains
plug|3 and remove the motor unit|1
from the drive cover|28.
6. Loosen the drive cover| 28 by turning it an-
ticlockwise.
7. Clean the device immediately if possible.