EasyManuals Logo

Silvercrest SSMS 600 E3 User Manual

Silvercrest SSMS 600 E3
34 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
10 GB/IE/NI/CY
If the supply cord is damaged,
it must be replaced by the
manufacturer, its service agent
or similarly qualified persons in
order to avoid a hazard.
Pull the power plug and not the
cable itself to disconnect the
product from the power supply.
Do not wrap the power cord
around the product. Connect
the product to an easily
reachable electrical outlet so
that in case of an emergency
the product can be unplugged
immediately.
Do not operate the product
with wet hands. Do not touch
the product with wet hands.
Operation
mWARNING: Potential injury
from misuse. Care shall be
taken when handling the sharp
cutting blades, emptying the
containers and during cleaning.
mDANGER! Danger of
scalding! Do not use the
containers with boiling liquids
or hot grease.
If you notice any smoke or
unusual noises, immediately
disconnect the product from
the power supply. Have the
product checked by a specialist
before continued use.
Always operate the product
on an even, stable and clean
surface.
Always disconnect the
appliance from the power
supply if it is left unattended
and before assembling,
disassembling or cleaning.
mWARNING: Switch off the
appliance and disconnect from
power supply before changing
accessories or approaching
parts that move in use.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Silvercrest SSMS 600 E3 and is the answer not in the manual?

Silvercrest SSMS 600 E3 Specifications

General IconGeneral
BrandSilvercrest
ModelSSMS 600 E3
CategoryBlender
LanguageEnglish

Related product manuals