Silvercrest SSTB 10 A1 User Manual

GB
│
IE
│
31 ■
SSTB 10 A1
Switch the device on/off
On the device
♦ Press and hold down the button for approx. 2 seconds to switch
on the device. The message +,appears briefly on the display and then
the most recently used operating mode ($8; or E/8() is shown.
♦ Press the button again for approx. 2 seconds to switch off the device.
The message 2)) appears briefly on the display .
With the remote control
♦ Press the button to switch on the device.
♦ Press the
button again to switch off the device.
Connecting a playback device
You can connect a wide variety of playback devices to this device, for
example MP3 or CD players. Please refer to the operating instructions of the
respective device. Switch off all devices before connecting them.
NOTE
► When playing back music via the AUX connections, the
(
+ )
,
( + ) and ( + ) buttons on the unit and the remote control are
inactive. You can, however, turn the MUTE function on and off using the
button . Use the Play/Pause and skip functions on the external playback
device that you have connected.
► Before starting playback, set a moderate volume. When you reach the
maximum volume, you will hear a signal and the volume can no longer be
increased.
Connecting a playback device using a 3.5mm jack cable
♦ Connect the line-out connector of the external device (e.g. headphone socket)
via a 3.5mm jack cable to the AUX 1 socket on the rear of the device.
♦ To switch on the device, press the button ( or ).
♦ Press the FUNCTION button on the device or the AUX button on
the remote control repeatedly until $8; appears on the display .
♦ Switch on the connected playback device and start playback.

Silvercrest SSTB 10 A1 Specifications

General

Brand	Silvercrest
Model	SSTB 10 A1
Category	Speakers
Language	English