EasyManua.ls Logo

Silvercrest SSVF 45 A1 - 7. Remote Control; Remote Control Usage; Remote Control Storage; Replacing Remote Battery

Silvercrest SSVF 45 A1
83 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11
GB
7. Remote control
How to use
The remote control31 is supplied with a
CR2025 (3V) battery inserted. Before
switching on, remove the plastic strip from
the remote control.
Storage
DANGER for children!
~ Keep the remote control and, if neces-
sary, old and new batteries out of the
reach of children.
Replacing the remote control
battery
DANGER!
~ There is a danger of explosion if the
battery is not correctly replaced. Re-
place only with the same or an equiva-
lent type.
NOTE: if possible, do not touch the top and
bottom of the battery with your fingers to
prevent dirt from getting on the battery con-
tacts. Use a clean cloth instead, for exam-
ple.
1. Press the small lever on the side of the
battery compartment gently in the direc-
tion of the middle (small arrow), and
then pull the battery compartment out of
the remote control (large arrow).
2. Replace the old battery with a new one.
The positive pole (+) of the battery must
be pointing upwards.
3. Slide the battery compartment into the
remote control31.
8. Operation
DANGER from rotating parts!
~ Only operate the fan when all accesso-
ries are fully assembled. The protective
grids1 and5 must be closed securely
and undamaged.
~ Do not insert objects through the protec-
tive grids1 and5 while the fan is run-
ning. Keep long hair away from the
rotating parts.
The device can be operated using the but-
tons on the operating panel8 or using the
remote control31. Unless otherwise de-
scribed, an acoustic signal sounds each
time a button is pressed.
__353132_2007_StandVentRC_B6.book Seite 11 Dienstag, 26. Januar 2021 1:26 13

Table of Contents

Related product manuals