EasyManua.ls Logo

Silvercrest SSWR B1 - Charging the Product; Initial Use

Silvercrest SSWR B1
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
30 GB/IE
suitable protective gloves at all
times if such an event occurs.
In the event of a leakage of bat-
teries / rechargeable batteries,
immediately remove them from
the product to prevent damage.
Only use the same type of bat-
teries / rechargeable batteries.
Do not mix used and new batter-
ies / rechargeable batteries.
Remove batteries / rechargeable
batteries if the product will not
be used for a longer period.
Risk of damage of the product
Only use the specified type of
battery / rechargeable battery!
Insert batteries / rechargeable
batteries according to polarity
marks (+) and (-) on the battery /
rechargeable battery and the
product.
Use a dry lint-free cloth or cotton
swab to clean the contacts on
the battery / rechargeable bat-
tery and in the battery compart-
ment before inserting!
Remove exhausted batteries /
rechargeable batteries from the
product immediately.
Robot vacuum cleaner only
This product features a built-in
rechargeable battery which
cannot be replaced by the user.
The rechargeable battery must
be removed or replaced by the
manufacturer or their service
centre or a similarly qualified
person to avoid hazards. When
disposing of the product, you must
indicate this product contains a
rechargeable battery.
Initial use
Charging the product
Fully charge the product before using it for the first time.
It takes approx. 4 to 6 hours to charge.
Set up the charging dock
9
and connect the
mains cable
11
. The indicator light
8
will
light up.
Place the charging dock
9
flush against a wall.
Note: Keep 1 m from the left / right and 2 m
from the front clear of other objects.
Before charging, turn on the power switch
5
on the product (Position “I”).
Place the product in the charging dock
9
and
align it with the charging contacts
10
.
You can alternatively directly connect the
mains cable
11
to the charging socket
6
on
the product.
Note: The product sometimes corrects its position
in the charging dock.
“Start / Pause” button
2
Charging in progress: flashes orange
Charging complete: light off
Standby mode: flashes green
Product error: flashes red
Low battery: orange light on
Suction mode: green light on
Note: The area around the charging dock
9
must
not have mirrors or other highly reflective objects
within 15 cm of the floor. If necessary, cover these.

Table of Contents