Silverline 196512 - Troubleshooting

GB
8
Symptom Possible Cause Solution
Tooloperatingslowly
Pressure incorrect Setthecorrectairpressureaccordingtothespecication
Dirtwithinthemechanism Pour oil into air inlet as per maintenance instructions
Air blockage Operate tool in short bursts to clear blockage
Air leak Checkallttingsandhoseforairleaksandcorrectissueby
re-tightening, using PTFE tape or replacing
Blockageingauzemeshlter RemoveQuickConnectorandcleanmeshlter
Tool seized
Dirt or rust in mechanism Try‘Tooloperatingslowly’solutions
Dirt or rust in mechanism Taptoolgentlywithasoftmallet
Dirt or rust in mechanism Freemechanismbyrotatingdrivemanuallywhendisconnectedfromairline
Strongvibrationswhentoolis
switchedon
Discttedincorrectly Removedisc,inspectfordamageandret
Disc damaged (cracks, deformations or splinters) Replace cutting disc
Flange damaged (burred or notched) Replaceange
Spindle bent Have the tool repaired by an authorised Silverline service centre
Toolwillnotstopaftertriggeris
fully released
Throttle valve O-ring or valve seat damaged Have the tool repaired at an authorised Silverline service centre
If the above troubleshooting solutions fail, contact your dealer or an authorised Silverline service centre.
Troubleshooting
196512_Manual.indd 8 30/08/2017 17:20