Carefully read and understand this manual and any label attached to the tool before use.
Keep these instructions with the product for future reference. Ensure all persons who use
this product are fully acquainted with this manual.
Even when used as prescribed it is not possible to eliminate all residual risk factors. Use
with caution. If you are at all unsure of the correct and safe manner in which to use this
tool, do not attempt to use it.
General Power Tool Safety
Warnings
WARNING! When using electric power tools, basic safety precautions should always be
followed to reduce the risk of fire, electric shock and personal injury including the following
safety information. Read all these instructions before attempting to operate this product
and save these instructions for future use.
WARNING: This appliance is not intended for use by persons (including children) with
reduced, physical or mental capabilities or lack of experience or knowledge unless they
have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety. Children must be supervised to ensure that they do not play
with the appliance.
CAUTION: Use the power tool, accessories and tool bits etc. in accordance with these
instructions, taking into account the working conditions and the work to be performed. Use
of the power tool for operations different from those intended could result in a hazardous
situation.
The term "power tool" in the warnings refers to your mains-operated (corded) power
tool or battery-operated (cordless) power tool.
1 - Keep work area clear - Cluttered areas and benches invite injuries
2 - Consider work area environment
- Do not expose tools to rain
- Do not use tools in damp or wet locations
- Keep work area well lit
- Do not use tools in the presence of flammable liquids or gases
3 - Guard against electric shock - Avoid body contact with earthed or grounded surfaces
(e.g. pipes, radiators, ranges, refrigerators)
4 - Keep other persons away - Do not let persons, especially children, not involved in the
work touch the tool or the extension cord and keep them away from the work area
5 - Store idle tools - When not in use, tools should be stored in a dry locked-up place, out
of reach of children
Description of Symbols
The rating plate on your tool may show symbols. These represent important information
about the product or instructions on its use.
Wear hearing protection
Wear eye protection
Wear breathing protection
Wear head protection
Wear hand protection
Read instruction manual
Class I construction (Protective earth)
Conforms to relevant legislation and safety standards
Environmental Protection
Waste electrical products should not be disposed of with household waste.
Please recycle where facilities exist. Check with your local authority or
retailer for recycling advice
4
GB
Specification
Voltage .......................................................... 230V~, 50Hz
Power ............................................................ 350W
Motor type ..................................................... Induction
Operating time (max) ..................................... 15min
No load speed ................................................ 600, 900, 1250, 1750
..................................................................... & 2600min
-1
Speeds .......................................................... 5
Chuck size ..................................................... 13mm (1.5 - 13mm)
Table size .......................................................160x160mm
Table Tilt ........................................................ +/- 45°
Chuck centre to column (throat) .................... 104mm
Chuck/Spindle Travel ..................................... 50mm
Chuck to base (max) ...................................... 250mm
Chuck to table ............................................... 0-173mm
Sound pressure:............................................. 73dB(A)
Sound power: ................................................86dB(A)
Uncertainty .................................................... 3dB
Protection class .............................................
Ingress protection .......................................... IP20
Weight ........................................................... 16.3kg
The sound intensity level for the operator may exceed 85dB(A) and
sound protection measures are necessary.
As part of our ongoing product development, specifications of Silverline
products may alter without notice.
Original Instructions
V
Volts
~
Alternating current
A
Ampere
n
o
No load speed
Hz
Hertz
W, kW
Watt, kilowatt
/min or min-1
(revolutions or reciprocation)
per minute
PDF Compressor Pro
To Next Page
Loading...
