SYSTEM OPERATIONS-2
The photo below shows the Unit Control Panel.
Each Air Conditioning Unit will operate in a “Dehu-
midifi cation” mode upon demand and is controlled
by the “Elite Control”. Refer to the Marine Systems
Operation and Maintenance Manual for a complete
description and instruction in the operation of this
mode.
Only certifi ed and trained service technicians should
perform maintenance of your Air Conditioning/Heat-
ing System. Contact your Silverton dealer for general
maintenance and winterization of the system on your
33C. Untrained persons may carefully perform rou-
tine maintenance, such as the cleaning of fi lters and
the exterior surfaces of the condensing coils.
Refer to the Marine Systems Operation and Main-
tenance Manual for technical information con-
cerning your Air Conidtioning/Heating System.
Operation of the Air Conditioning/Heating
System in your 33C is as follows:
Turn ON the respective Air Conditioner
Breaker Switch, located on the AC/DC
Electrical Panel (See AC/DC Electrical
Pages in the System Operations Sec-
tion of this manual).
Make sure Seawater Intake is open and
Seawater Pump is operating properly.
Refer to the Marine Systems Operation
and Maintenance Manual for a detailed
description of the function of each but-
ton located on the “Elite Control”.
Both Air Conditioning Units create con-
densation, which creates water that has
to be drained. The forward unit drains
into the Shower Sump Pump. Make
sure Shower Sump Circuit Breaker
is turned on when operating the Air
Conditioning.
Turn ON the power button, located on
the respective air conditioning unit “Elite
Control”.
Press the fan speed button on the
“Elite Control” until the desired speed
is obtained.
Press the appropriate temperature
control button (Down/Up) to obtain the
desired temperature.
•
•
•
•
•
•
•
To Next Page
Loading...