GETTING FAMILIAR-3
TRANSOM ANODE PLATE
The photograph below displays the Transom Anode
Plate, which is a sacrifi cial zinc anode that is bolted to
the transom and connected to the electrical bonding
system. Its purpose is to help in reducing the effects
of electrolysis and galvanic corrosion of the underwater
components in your yacht, which is discussed in the
Bonding System pages in the Systems Operation sec-
tion of this Owner’s Manual.
TRIM TABS
The photograph below displays the Port Trim Tab,
which is factory installed on the lower edge of the
transom (The starboard trim tab is located in the same
location on the opposite side of the transom). The
purpose of the Trim Tabs is to assist in controlling the
angle, both longitudinally and athwartships, that your
yacht rides in the water during forward movement.
The control panel for the Trim Tabs is located at the
Helm Station.
PROPELLERS
The photographs below display the Propeller rotation
for the Port and Starboard sides.
ENGINE EXHAUST PORTS
There are two Engine Exhaust Ports; one for each
engine. The Port Engine Exhaust Port is located on
the Port side of the Hull, forward of the Transom. And
the Starboard Engine Exhaust Port is located on the
Starboard side of the Hull, forward of the Transom.
To Next Page
Loading...