Sim2 DOMINO Series - Leds Lightning Indications

LED lightning indications
POWER LED is bi-color (Blue and Red).
TEMP LED indicates the projector has overheated.
LIGHT LED indicates the projector light source functionality. Status OFF indicates
that not errors or warnings are present.
If one of the following status, shown in the table below, happens, unplug the power
cord from the projector, wait for 30 seconds and try again. If the warning indicator
light up again, please contact your nearest service center for assistance.
* ON/STANDBY LED be ON when OSD appears, be OFF when OSD disappears.
MESSAGE
POWER LED
(Red)
POWER LED
(Blue)
TEMP LED
(Red)
LIGHT LED
(Red)
Standby State
(Input power cord)
Steady Light*
O
O
O
Power On
(Warming)
O
Flashing
O
O
Power On and Light
Lighting
O
Steady Light
O
O
Power O
(Cooling)
O
Flashing
O
O
Error
(Light fail)
Flashing
O
O
Steady
Light
Error
(Fan fail)
Flashing
O
Flashing
O
Error
(Over Temperature)
Flashing
O
Steady Light
O
28
Power
LEDs
Temperature
Light source
DOMINO4-H 25-28
User Guide