Note: When the projector recognize an HDR content, in the signal, it will switched the
Display Mode in HDR or BrightHDR. Between these two last modes, it will selected
the last one selected from the user. Example: if the projector is displaying a video,
not HDR, and the present Display Mode is Natural, when the user will switch to an
HDR signal, also the projector will change the present Display Mode in HDR or
BrightHDR. At the moment that the user will come back to the signal without HDR
content, also the projector will select the previous Display Mode, for this example, the
Natural.
Same behavior when the projector recognize a video processed with the Hybrid Log-
Gamma: it will switched the Display Mode in “HLG” or “BrightHLG”.
Note: The HDR
10
signals are processed only if they coming from the HDMI2 input,
that is compliant with the standard HDMI v.2.0a - HDCP 2.2.
Note: The HLG signals are processed only if they coming from the HDMI2 input.
Note: The Display Mode depends on the input source and timings. For example, the
display mode will be dierent from HDMI and VGA. If you change any of the image
settings, the display mode presets will be changed and saved automatically. If you
want to return to the factory default display mode, select RESET from the menu
SETUP.
Noise Reduction
This adjustment lets you choose the value of the noise reduction filter. The Noise
Reduction reduces the amount of visible interlaced signals.
Press to decrease the noise reduction
Press to increase the noise reduction
Range [O, 1, 2, 3]
HDR Settings
This adjustment lets you choose the standard SMPTE 2084 curve, that better match
the characteristic of your installation.
AUTO: this mode selects one EOTF SMPTE 2084 curve preset, between HDR1, HDR2,
HDR3 and HDR4, depending of signal content.
SDR: this mode is suitable for showing images without HDR contents.
HDR1: this mode is suitable for showing HDR contents with the SMPTE 2084 curve
for the following setup: screen dimensions of 100 inches and projector's lens set in
wide angle.
HDR2: as HDR1, but for screen dimensions of 120 inches.
HDR3: as HDR1, but for screen dimensions of 140 inches.
HDR4: as HDR1, but for screen dimensions of 160 inches.
HLG1: this mode is suitable for showing HDR HLG contents with the SMPTE 2084
curve for the following setup: screen dimensions of 100 inches and projector's lens
set in wide angle.
HLG 2: as HLG1, but for screen dimensions of 120 inches.
HLG 3: as HLG1, but for screen dimensions of 140 inches.
HLG 4: as HLG1, but for screen dimensions of 160 inches.
To Next Page
Loading...
