SIMAG SDE Series - Ice Cube Production Stop

10
F05
A
B
C
Ice cube production stop
To block the cyclical production of ice, press the ON/OFF switch (if present). In the models without the ON/OFF
switch, to stop production, unplug or turn OFF the switch that powers the socket or the electrical panel to which the
appliance is connected.
Even if the key is o, the appliance is still powered up.
Turning the appliance o
To turn the appliance o, for example to carry out cleaning or at the end of the working day, unplug the appliance or
turn o the switch that powers the socket or the electrical panel to which the appliance is connected.
These appliances have
a built-in ice container:
door “A” must be lifted to
remove the ice.
If you are not taking the
ice, the ice container
door must be kept closed
to prevent incorrect
interventions of the
thermostat located inside
the container.
water supply tap
water loading for cooling (only for machines
with water condensation)
water loading for ice
production
ice container door “A”
depending on the model
there may be a plug
A
and a
switch
B
to disconnect it if
it is in a dicult position or an
electrical panel
C
F05
After about 20-30 minutes (depending on the model) the rst cubes will be released which can then be
removed from the container using the scoop provided. Subsequently, at intervals of about 20-30 minutes
other ice cubes will be released continuously, without needing to press any button.
To avoid excessive lling of the integrated container and possible ice cube spills, inside the container there is a
container thermostat which stops production if the maximum capacity level is exceeded.
When the cubes are withdrawn and the level drops, the appliance automatically resumes production without the
need for any operation on the part of the user.
After taking the ice, the scoop must be placed inside the collection container; to avoid contamination of the ice, use
only the scoop provided and sanitize it frequently.