EasyManua.ls Logo

SIMAG SDE Series - Cleaning and Maintenance of the Appliance; Ordinary Cleaning

Default Icon
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
12
F06 F07
INOX
1 ml +
+
1 l
H
2
O
DD
U
S
O
P
RO
F
E
S
S
I
O
N
A
L
E
SOLUZIONE
Clorossidante elettrolitico
DISINFETTANTE
CONCENTRATA
Ordinary cleaning
Before carrying out any ordinary or
extraordinary maintenance, it is
necessary to disconnect the appliance from
the power supply, close the water supply tap
and wear appropriate personal protective
equipment (e.g. gloves, etc.).
Ordinary cleaning is intended to keep the appliance in
good operating condition and prevent the proliferation of
bacteria.
To clean any component or accessory DO NOT use:
abrasive or powder detergents;
aggressive or corrosive detergents (for example
hydrochloric or sulphuric acid, caustic soda, etc.).
Caution! Never use these substances also when
cleaning the floor under the appliance;
abrasive or sharp tools (for example abrasive sponges,
scrapers, steel brushes, etc.);
steamed or pressurised water jets.
The user must carry out only routine maintenance,
for any extraordinary maintenance, contact a Service
Centre requesting service from an authorised
technician. The cleaning of the appliance is reserved
only for suitable and capable personnel and must not be
carried out by children.
CLEANING AND MAINTENANCE OF THE APPLIANCE
DAILY
Clean the ice scoop with the manufacturer’s
disinfectant mixed with warm water (1 ml in 1 litre of
water, the dilution percentages are also indicated on
the rear label of the product). Finish rinsing and drying it
thoroughly.
MONTHLY
Clean the ice collection compartment with a soft
cloth soaked with the manufacturer’s disinfectant mixed
with warm water (1 ml in 1 litre of water, the dilution
percentages are also indicated on the rear label of the
product). Finish with a thorough rinsing.
Clean the external surfaces with a soft cloth
moistened with a specic product for stainless steel, free
of acid, aggressive or abrasive agents. For how to use it,
refer to the instructions provided by the manufacturer of
the chosen detergent.
The manufacturer’s
disinfectant is the
only one tested
and guaranteed to
thoroughly sanitize all
surfaces in contact
with the ice, in full
compliance with
the construction
materials.
Contact the ocial
local Manufacturer/
Distributor for any
purchase.

Related product manuals