Need help?Do you have a question about the simatherm IH 070 and is the answer not in the manual?
Defines the primary purpose of the IH 070/090, including heating rolling bearings and other metal workpieces.
Explains how the induction heater generates heat by magnetically inducing electrical current in the workpiece.
Highlights the unique design of the workpiece location on the core for improved efficiency and faster heating.
Lists and describes the main parts of the IH 070/090 induction heater, including the core, coil, supports, and yokes.
Provides detailed technical specifications for the IH 070 and IH 090 models, including voltage, power, and dimensions.
Details the main display and power display indicators and their meanings during operation.
Explains the function of each button on the control panel: POWER, MODE, UP, DOWN, and START/STOP.
Guides the user on how to select and use the temperature-controlled heating mode, including default settings and adjustments.
Explains how to select and use the time-controlled heating mode, including setting time and power levels.
Describes how to measure workpiece temperature when the heater is not operating.
Instructions on how to switch the temperature display between Celsius (°C) and Fahrenheit (°F).
Explains the automatic demagnetisation process after heating and how to use the heater for demagnetisation only.
Provides guidelines for selecting appropriate power levels based on workpiece type, yoke, and sensitivity.
General| Shaft Diameter min. | 20 mm |
|---|---|
| Voltage | 200-240 V / 400-480 V |
| Frequency | 50/60 Hz |
| Thermostat | Yes |
| Overheat Protection | Yes |
| Power | 3.5 kVA |
To Next Page