smart mounting
®
34 Induction Heater IH 070/090 © simatec ag
7 Troubleshooting
A system fault will be indicated by an acoustic signal and one of the
following fault codes on the main display:
Display Fault Action
E01 E General system failure Return IH 070/090 for repair.
E02 E Memory failure Return IH 070/090 for repair.
E03 E Overheated coil Wait until the inductive coil cools.
E04 E not in use
E05 E Temperature increase
of less than 1° every 15
seconds (or 1° every 30
seconds)
Check the temperature probe
connection. If the connection is OK,
select the 30 second interval as
described in section 6 or operate the
heater in TIME MODE.
E06 E Temperature probe not
connected (or defective)
Check the temperature probe.
E07 E Failure during current
measurement
Return IH 070/090 for repair.
E08 E Failure during communi-
cation with power printed
circuit board
Return IH 070/090 for repair.
E09 E Overheated printed circuit
board
Wait until the printed circuit board
cools.
To Next Page
Loading...