Simaudio Moon 340i x - Page 10

MOON by Simaudio
The “A2” input can be configured as a “pass-
through” which bypasses the 340i’s gain control
section, allowing you to control the gain setting
viathe connected source component’s
ownvolume control – a home theater processor
forexample; In other words, this input operates
like the input of a power amplifier. In “pass-
through” mode, adjusting the volume onthe340i
will have no effect whatsoever whenthe “A2”
input is selected. To put the “A2” input into
“pass-through” mode, press and hold down
the“Mute” button for approximately 2seconds
while on the “A2” input. The front panel display
will change from “A2” to “HT”. Toreconfigure
the“A2” input to function like theother inputs,
repeat the this procedure. Powering down
the340i via the rear panel rocker switch
willautomatically reset the the “A2” to thefactory
default ‘normal’ mode.
The rotary “Volume” control determines theoutput
level. The volume control hasanembedded
redLED to indicate its actual position.
The “Phones” jack is used for connecting a pair
ofstereo headphones to the MOON 340i.
Theinput connector is a standard ¼” stereo TRS
jack. When a pair of headphones are used
withthe340i, the loudspeakers will still receive
anoutput signal. However, you should
usetheaforementioned “Spk off” button
forprivate listening.