44
EN
The client is responsible for the
installation.
The manufacturer or the importer
assume no liability for any damage
caused by improper installation or by
non-compliance with the instructions
contained in this manual and specifically
in case of:
– the installation must be carried
out by a professional or authorised
personnel;
– the wiring must comply with the
specifications contained in this
manual;
– make sure that the tank is full of water
before connecting it to a power supply.
– there must be no water leaks in the
connections before connecting it;
– be sure to use the accessories supplied
with the appliance;
– the dielectric unions supplied must be
installed;
– the installation and maintenance of
the appliance must be carried out
by qualified personnel according to
current standards, and in accordance
with the instructions in the manual;
– the water heater must be used
domestically (hair salons, gyms, etc.,
are considered as industrial use).
2
GENERAL INSTRUCTIONS AND RECOMMENDATIONS
2.1 Preliminary advice
NOTE
The water used in the system must
meet the manufacturer’s requirements
regarding pH, conductivity, hardness,
alkalinity, chloride concentration,
inadequate values give rise to the non-
provision of the guarantee, the values
of the system fluid must be within those
listed below:
• The content of soluble salts will not
exceed 500 mg/l.
• The conductivity must not exceed 650
μS/cm.
• The pH of the fluid, with a temperature
of 20º, must be between a minimum of 6
and a maximum of 8.
• The total hardness of the water must
not exceed 30º F,
It is recommended to treat the water
when the hardness of the fluid is
higher than the established limits, total
hardness, salinity, high conductivity.
(polyphosphates, softener, etc,)
To Next Page
Loading...
