Simer 3075SS - User Manual

Questions and Answers

L
loliverJul 29, 2025
What to do if my Simer 3075SS Water Pump motor runs but no water comes out?
- B
  Barbara GallowayJul 30, 2025
  If the motor of your Simer Water Pump is running but no water is being delivered, there are several potential causes and solutions: * **Improper priming:** Re-prime the pump according to the instructions. * **Clogged water filter:** Stop the pump, shut off the water, and change the filter cartridge. Ensure the filter is installed on the discharge side of the pump. * **Discharge valve closed:** Open the valve. * **Pipe size too small:** Re-pipe using pipe of the same size as suction and discharge ports on the pump. * **Impeller is plugged:** Clean the impeller. * **Pipes are frozen:** Thaw the pipes.
S
Steven SchultzAug 6, 2025
Why is my Simer 3075SS Water Pump not delivering water to full capacity?
- G
  Gail MendezAug 6, 2025
  If your Simer Water Pump isn't delivering water to its full capacity, consider these possible causes: * **Corroded pipes:** Replace them with plastic or new steel pipes. * **Piping is too small in size:** Re-pipe using pipe the same size as the suction and discharge ports on the pump. * **Pump not being supplied with enough water:** Enlarge the inlet pipe and check the well pump system. * **Low voltage:** Ensure the outlet is at 115 Volts.
J
jenniferrobertsAug 13, 2025
What to do if my Simer 3075SS Water Pump motor runs hot and the overload kicks off, or it only hums?
- M
  mespinozaAug 13, 2025
  If your Simer Water Pump motor runs hot and the overload kicks off, or if it only hums, here are a couple of things to check: * **Voltage is too low:** Check the voltage being supplied to the pump. * **Impeller not moving freely:** Make sure the impeller moves freely and isn't clogged.
T
Tammy DavisAug 20, 2025
How to fix a Simer 3075SS when the motor will not run?
- D
  darin40Aug 20, 2025
  If the motor of your Simer Water Pump won't run, it could be due to a blown fuse, a tripped circuit breaker, or the power cord not being plugged in. Disconnect the power, then replace the fuse or reset the circuit breaker. Ensure the pump is plugged into a 115 Volt grounded outlet.