Simplex 4004 Installation Instructions

574-077
Rev. B
9. Connect Wiring Harness (733-897, supplied) from System Board P5 to
DACT module P2, P5, and TB1.
10. Power-up and configure the 4004 System for the DACT module using the
programming instructions located on the Contractor Wiring Termination
Label (519-698) on the door.
11. Program the DACT in accordance with the installation/programming
manual that is supplied with the DACT.
REGISTRATION LABEL
TELCO WIRING
DACT MODULE
LEDS
DACT MODULE
CUT OUT SLOT
OPENING
DACT MODULE
MOUNTING LOCATION
MOUNTING PLATE
Figure 2. Exploded View of 4004 Panel
DACT Module Installation, Continued
Screw Mounting Method
(Continued)
Technical Manuals Online! - http://www.tech-man.com

Simplex 4004 Specifications

General

Brand	Simplex
Model	4004
Category	Smoke Alarm
Language	English