Simplex 4100ES - Page 55

7-1
The Install Mode is a 4100ES feature that allows the user to minimize the amount of Troubles
that occur when the system is being installed or when it is undergoing extensive service.
Install Mode allows the technician to select device points and cards that might raise Troubles
due to installation issues and place them in “Install Mode”. Install Mode will only raise one
Trouble “INSTALL MODE ACTIVE”, regardless of the number of items in it.
Install mode is available on Panels programmed with a revision 1.01 of the ES Programmer or
later.
This chapter covers the following topics
Topic Page
Accessing Install Mode 7-2
Adding and Removing Items to and from Install Mode 7-3
Adding and Removing Points and Cards 7-3
Adding and Removing Lists 7-4
Adding and removing groups to Install Mode 7-4
Viewing Install Mode 7-5
Chapter 7
0B Install Mode
4
Introduction
I
n
this
ch
ap
t
er
firealarmresources.com