Need help?Do you have a question about the Simplex 4100 Classic and is the answer not in the manual?
General| Type | Fire Alarm Control Panel |
|---|---|
| Manufacturer | Simplex |
| Model | 4100 Classic |
| Voltage | 120/240 VAC |
| Battery Backup | Yes |
| Battery Backup Voltage | 24 VDC |
| Operating Temperature | 32°F to 120°F (0°C to 49°C) |
| Frequency | 60 Hz |
| Communication | Optional |
| Display | LCD |
| Annunciator Support | Yes |
| Networking | Optional |
| Humidity Range | Up to 93% RH, non-condensing |
Guides on how to reset latched faults and reboot the CPU for troubleshooting.
Details various faults related to loop cards (MAPNET or IDNET) on the panel.
Explains the 'Card Missing/Failed' fault and its possible causes.
Covers 'Short Circuit Abnormal' faults on addressable loops, including wiring issues.
Explains how to set DIP switches for IDNet device addressing.
Lists and describes faults related to addressable devices on the loop.
Covers the 'No Answer' fault, indicating a device is not responding.
Explains the 'Wrong Device' fault when a device doesn't match programming.
Describes 'Extra Device' faults where an unprogrammed device is detected.
Details faults related to the 4100-0157A battery charger and its troubleshooting.
Covers detection and location of positive/negative earth ground faults.
Lists specific crash codes, their LCD display, error, and information.
Continues the table of crash codes, errors, and information for the 4100 family.
To Next Page
