Simplicity 6100 Series - Starting after Storage; Lubricate Mower

1. To empty or prepare fuel tank:
a. Run tractor engine until it stops
from lack of fuel, or;
b. Use a gasoline stabilizer. This ad¬
ditive, available from your dealer,
prevents formation of gum and
varnish for up to one year. With
the additive, fuel may remain in
your tank for long periods.
2. Change engine oil while the engine is
still warm. Record the type and weight
of oil put in crankcase.
3. Remove spark plug(s). Pour one ounce
(30 ml) of SAE 30 oil into engine
through spark plug hole(s). Crank
engine a few times to distribute oil and
then reinstall the spark plug(s).
4. Lubricate tractor. (See page 12.)
5. Check battery fluid level (page 13).
Battery life will be extended if it is
removed and stored in a cool, dry
place, fully charged.
6. Clean tractor thoroughly. Coat all
exposed bare metal (unpainted) parts
with a good quality paint (obtainable
from your dealer) or a light film of
grease or oil. Keep oil off belts and
pulleys.
STARTING AFTER STORAGE
1. Replace battery, if removed. Be sure
terminals and clamps are clean (see
page 14).
2. Remove spark plugs and wipe dry.
Crank engine a few times to blow
excess oil out of plug holes. Then
reinstall the plugs.
3. Fill fuel tank with fresh gasoline (un¬
less a fuel stabilizier was used).
4. Clean engine fins and air filter. (See
engine manual.)
5. Check fluid levels and tire pressure.
(See page 13.)
6. Start the engine outdoors. Do not run
engine at high speeds immediately
after starting.
iNpriri Qj Cajei
LUBRICATE MOWER
Lubricate all points where metal rubs against
metal. For the 42" or 48" mower, lubricate
the points shown in figures 13 thru 15. For
the 36" mower, lubricate the points shown in
figures 16 thru 18. Use an oil can with
medium weight (SAE 30) oil. Brush and
wipe dirt and grass from the area before
applying oil. Wipe up drips or spills. Keep
oil off belts and pulleys.
Lube Points: Height Control Lever;
Point Where Roller Bar Contacts
Bracket.
Figure 13. Mower Height Control