Simplicity 7800893 - Starting the Mower; Propelling the Mower

13
Fuel Recommendations
Fuel must meet these requirements:
•Clean,fresh,unleadedgasolinewith
•Aminimumof87octane/87AKI(90RON).
•Gasolinewithupto10%ethanol(gasahol)orupto
15%MTBE(methyltertiarybutylether)isacceptable.
•CAUTION: DO NOT use unapproved gasoline, such
as E85. Do not mix oil in gasoline or modify the engine
to run on alternative fuels. This will damage the engine
components and void the engine warranty.
The engine on this equipment is certified to operate on
gasoline. The emissions control system for this engine
is EM (Engine Modifications).
High Altitude
At altitudes over 5,000 feet (1524 meters), a minimum
85 octane/85 AKI (89 RON) gasoline is acceptable.
To remain emissions compliant, high altitude adjust-
ment is required. Operation without this adjustment will
cause decreased performance, increased fuel con-
sumption, and increased emissions.
Operation of the engine at altitudes below 2,500 feet
(762 meters) with the high altitude kit is not recom-
mended.
Starting the Mower
The engine on this mower is equipped with a
ReadyStart
®
system, which features a temperature-
controlled automatic choke. It does not have a manual
choke or a primer.
1. Make sure the drive handle (A, Figure 5) is pulled
fully back, and the drive handle lock lever (B) is
fushed fully forward in the ‘Lock’ position.
2. Squeeze and hold the blade control (C) against
the handle.
3. Start the engine (and blade):
Manual Start: Pull the rope start handle (D) to start
the engine.
Electric Start (Model 7800894): Insert the key (E)
into the ignition switch (F). Turn the key to start
the engine. Use short starting cycles (5 seconds
max.), and wait 1 minute between attempts.
4. To stop the engine (and blade), release the blade
control.
5. After the engine starts, allow a brief warm-up until
the engine runs smooth before beginning mower
operation.
Figure 5: Starting the mower
B
A
C
F
D
E
Propelling the Mower
1. Start the mower.
2. Pull the drive handle lock lever (A, Figure 6) fully
back to the ‘Unlock’ position.
3. Begin pushing the drive handle (B) forward to
engage the wheel drive and propel the mower for-
ward. Forward speed can be increased by pushing
the drive handle farther forward, and decreased by
pulling the drive handle back.
Operation
en
Not for
Reproduction