SimpliSafe Water Sensor User Manual

visit www.simplisafe.com or call 1-888-95-SIMPLI (957-4675) for additional assistance
8
visit www.simplisafe.com or call 1-888-95-SIMPLI (957-4675) for additional assistance
Install your Entry Sensors
`
•Remove the battery activation strip.
•Align the magnet with the sensor’s grooves
so the two pieces are less than 2 inches
apart when the door or window is closed.
Tip: Test the alignment before you adhere each piece.
The blue light should flash once when the door or
window opens and twice when it closes.
•Adhere the Sensor on the door and the
magnet on the doorframe, or the other way
around. There is no “right side up.”
Sensor
Magnet
Grooves
Closed—magnet is within 2
inches of the sensor, aligned
between the sensor grooves.
Window Example
Door Example

SimpliSafe Water Sensor Specifications

General

Type	Water Sensor
Compatibility	SimpliSafe security system
Power Source	Battery
Battery Type	CR2032
Connectivity	Wireless
Detection	Water leakage
Placement	Near potential water sources (e.g., under sinks, near water heaters)
Alerts	Mobile app notifications, system alerts
Operating Temperature	32°F to 104°F (0°C to 40°C)
Operating Humidity	Up to 85% non-condensing
Wireless Range	800 feet open air