Simpson 2 Series - Phenolic Case; Adjust-A-Vue Handle

General Description
volt D.C. range, use the red test lead connected to the
SOLAMPS jack. For the 10 ampere D.C. range, use the
black test lead in the - 10 A. jack and the red test lead
in the +10 A. jack.
PRINTED CIRCUIT
Conforming to the latest engineering developments, almost
all the component parts of the Simpson Model 270 Series 2,
are mounted in a printed circuit. This simplifies assembly,
reduces maintenance, and extends the useful life of the
instrument (See page 28 for removal instructions).
PHENOLIC CASE
The Simpson Model 270 Series 2 is housed in a heavy black
phenolic case. It is molded with heavy reinforced walls for
maximum durability. All the component parts in the Model
270 Series 2 are attached or mounted to the front panel: the
entire instrument slips into and out of the case in one piece.
ADJUST-A-VUE HANDLE
The comfortable handle is attached on each side of the
instrument case. The handle may be used to support the
instrument in a convenient sloping position for easy view-
ing on the bench top. Of course, the Model 270 Series 2
can also be placed in either a vertical or horizontal posi-
tion (see note at bottom of page 9).
TEST LEADS
Each Simpson Volt-Ohm-Milliameter Model 270 Series 2 is
furnished with one pair of four-foot test leads. One lead is
black and the other red for easy polarity identification.