Normal drying (high temperature)
Do Not Tumble Dry
Delicate drying (low temperature)
Permanent press and synthetics – take out as soon as the dryer stops to reduce wrinkles.
Woolen articles- not recommended. Pull them to their original shape, then dry them flat.
Woven and loop knit materials – may shrink, by varying amounts, depending on their quality. Do not use the ‘hot’ setting for these fabrics. Always stretch them out immediately after
drying.
Fiber or leather materials- always check the manufacturer’s instructions.
Baby clothes and nightgowns- acrylic clothing or sleepwear use only on the ‘warm’ setting.
Rubber and plastics- Do not dry any items made from or containing rubber or plastics, such as aprons, bibs, babies’ waterproof napkins, curtains, tablecloths, shower caps, clothes
fitted with foam rubber pads, pillows, galoshes, or rubber-coated tennis shoes.
Fiberglass- not recommended. Glass particles left in the dryer could be picked up by your clothes the next time you use the dryer, and irritate your skin.
During the drying cycle, if you want to
add or take out clothes, or
check the dryness of the load,
turn down the timer to ‘Airing’ for at least one minute before opening the door. This is to prevent scorching or possible self-combustion of the fabric.
Fabric softeners or similar products should not be used in a tumble dryer to eliminate the effects of static electricity unless this practice is specifically recommended by the manufacturer of
the fabric softener or product.
Note: We strongly advise against the use of fabric conditioners of the sheet type that are added to the clothes in the drum. These products may lead to rapid blockage of the lint filter and
inefficient operation of your dryer.
Installation Instructions
You can choose to put your dryer:
on the floor.
on a workbench.
on a wall, upside down or upright, using the included mounting kit.
on top of a front load washing machine (using a stacking kit available as an optional extra).
The appliance must not be installed behind a lockable door, a sliding door, or a door with a hinge on the opposite side to that of the tumble dryer in such a way that a full opening of the
tumble dryer door is restricted.
Stacking Kit,
You can use a stacking kit if you want to mount your dryer on top of a Simpson front load washing machine. Use the kit part number DKSK03. Refer to the kit instructions on how to install.
The exhaust grille has a range of positions, which allows you to select the optimum exhaust air angle. Simply hold the
grille and rotate it until it hits the built-in stop.
removable exhaust grille
Name Badge
You can invert the name badge when you want to mount your dryer upside down on the wall. Use a suitable tool (such as a thin-bladed tool). Unclip the badge from the panel, invert and clip
back.
Do not install your dryer in a cupboard or small un-vented laundry unless you are using a venting kit.
There are 2 VENTING OPTIONS
front
rear – using a venting kit (optional extra)
Venting Kit
DVK005 – Through the wall
To Next Page
Loading...
