CR40/42/50 MKII Installation manual Chapter 9
140
cable through the cable inlet, place the rubber ring around the cable, and clamp
the cable to the scanner unit with screws via the fixing plate.
See ‘Fitting interconnecting cable’ for RB714A and RB715A further on in this
section.
RB714A: Connect 10-pin connector to X1.
RB715A: Connect 7-pin connector to X11 and 9-pin connector to X12 of PCB.
Replace the aluminum cover: Attach a cable shield onto a ditch with the alumi-
num cover. Be careful that the cable does not get caught between main unit and
cover, and that the antenna is free to rotate.
Replace the upper part of the radome: Be careful not to bump it against the
antenna. Be sure that the cover is fitted in the correct direction (refer to below
illustration). Align the upper and lower parts with the holes for the screws.
Ship's
heading
Logo seal on
side wall
Fix four screws
Cable inlet
To Next Page
Loading...
