Simrad CR40 MKII - 6 Navigation Menus; NAV Menu (NAV Inactive); Navigation Display

CR40/42/50 MKII NAV menus & navigation examples Chapter 6
65
6.1 NAV menu – (NAV inactive)
_4_
NAV
_1_ Navigation
- see section 6.1.1.
_2_ Waypoint
- see section 6.5.2.
_3_ Route
- see section 6.5.3.
_4_ Track
- see section 6.5.4.
_5_ Anchor guard
- see section 6.3.
This NAV menu will appear when there is no navigation mode active.
See also section 6.2 –whennavigationmodeisactive,section6.3
Anchor guard, 6.4 MOB navigation, and 6.5 Navigation examples.
6.1.1 Navigation display
MENU
Call up the menu bar, and…
4,1
load Navigation display
Since there is no navigation mode active, you will receive the legend:
NAVIGATION IS OFF. To enter the basic Navigation setup display:
ENT
Press
[ENT]
to call up Navigation setup
- see display example next page.
The default settings in the navigation setup display can only be edited
when the relevant navigation mode is active; except for the anchor
alarm settings, which can be edited at any time.