Simrad CR40 MKII - Page 64

CR40/42/50 MKII Waypoint/route menus Chapter 5
64
+/-
Use the +/- zoom keys to toggle between DATABANK 1 and 2
Load from DataCard:
DATABANK-1
Data generated by: Simrad CR40
Used internal memory: 672 bytes = 0%
Used DataCard memory: 85332 bytes = 19%
Used internal memory after operation: 85332 bytes = 19%
Save date: 24-08-2000
Save time: 09:26:59
Name: MR14
Data type Amount Size
Marks/waypoints: 52
[byte]
1120
Lines: 2 284
Routes: 8 6280
Targets: 3 72
Tracks: 5 75287
Setup: 1 2289
Exit Load from DataCard
ENT
Press [ENT] x 2 to transfer a copy of the data in DATABANK 1 to the
internal memory in the unit. Any existing data in the internal memory
will be overwritten, except when a TL50 Turbo Loader is connected to
the unit, then you can decide which data should be overwritten - refer
to TL50 manual.
MENU
Press [MENU] to Exit, and reboot
) When the system makes a ‘reboot’ the screen will turn black for a
brief moment, then the system will re-start and automatically return to
the active display which was on the screen before you made the
transfer.
MENU
ENT