Simrad CR40 MKII - Delete Tracks Via Menu; Targets Stored in the Memory

CR40/42/50 MKII Waypoint/route menus Chapter 5
60
ENT
Open for change
“Display track” can be set ON/OFF, where OFF will make it invisible
on the screen. Turn ON to put it back on the screen.
+/-
Toggle between available values
ENT
Confirm changes
5.6.1 Delete tracks via menu
MENU
Call up the menu bar, and…
3,7
load track display
+/-
Select the track you wish to delete
ENT
Press [ENT] to open for editing
WIN
Press [WIN] to delete the track
CLR
Confirm
) Edit tracks directly on the chart via info windows. Refer to section
3.3.6.
5.7 Targets stored in the memory
The CRXX can display the bearing and distance of up to three targets
at a time in relation to the vessel e.g. harbors or important navigational
points. A target is a fixed point on the chart which can be plotted by the
cursor or from the ship’s position, or keyed in via the keypad.
Set up targets
The plotted target position is automatically preset to actual position of
ship, or to cursor position when the chart display is active and the
cursor is on – see INFO windows, section 3.3.7.