Autopilot
The autopilot can be activated from any panel.
1. Tap the Autopilot tile in the Instrument bar.
2. Select the autopilot mode in the Autopilot pop-up.
S Standby Autopilot is passive. Used when manually steering at the helm
FU Follow-up *
The rudder angle is set by OP40 (accessory). The rudder will be
moved to set angle
NFU
Non-Follow-
up
The rudder movement is controlled by the Port and Starboard
buttons in the Autopilot pop-up, or by another NFU unit
A Auto Automatic steering: maintaining the set heading
ND NoDrift
Automatic steering: keeping the vessel on a straight bearing
line by compensating for drift
N Navigation
Automatic steering: navigating the vessel to a specific
waypoint or through a route using GPS data
W Wind ** Automatic steering: maintaining the set wind angle
WN
Wind
navigation **
Automatic steering: navigating the vessel to a specific
waypoint or through a route using both wind and GPS data
* Not applicable for virtual rudder feedback configurations.
** Only available if the boat type is set to Sailboat.
¼ Note: You switch the autopilot to Standby mode from any automatic mode by a
short press on the
Standby button in the Autopilot pop-up.
Adjust set heading / course / wind angle
Adjust set heading (Auto mode), set wind angle (Wind mode) and
set course (NoDrift mode) by tapping the Port or Starboard but-
tons in the autopilot pop-up.
For more details, see the NSO evo2 Operator manual.
To Previous Page
Loading...
