For further details about wireless setup and connectivity, refer to the Operator Manual.
Network settings
Device name
Assigning a name is useful in systems using more than one device of the same type and size.
Sources
Data sources provide live data to the system.
When a device is connected to more than one source providing the same data, the user can
choose the preferred source. Before commencing with source selection make sure all
external devices and networks are connected and turned on.
Auto Select
The Auto Select option looks for all sources connected to the device. If more than one source
is available for each data type, selection is made from an internal priority list. This option is
suitable for the majority of installations.
Manual source selection
Manual selection is generally only required where there is more than one source for the same
data, and the automatically selected source is not the one desired.
Group source selection
The unit can use the same data sources that all other products on the network use, or
alternatively use a data source independently from other units.
If the unit is part of a source group, all source selection changes will affect all units belonging
to the same group.
Ú
Note: In order to enable group selection, the unit must be set to the Simrad group.
Devices with no selected group can use different sources than the rest of the network
devices.
Advanced source selection
This allows the most flexible and precise manual control over which devices provide data.
Occasionally auto select might not assign the desired source, which can be corrected using
the advanced source selection.
Software setup | NSO evo3S MPU Installation Manual
To Next Page
Loading...
