Simrad NSS evo2 - Page 7

Autopilot
You can activate the autopilot from any panel.
1. Press the
STBY/AUTO key or the Autopilot tile in the Instrument bar
2. Select the autopilot mode in the Autopilot pop-up
S Standby
Autopilot is passive. Used when manually steering at the
helm
FU Follow-up
Manual steering. The rudder angle is set by the Rotary knob
or by another FU unit
NFU Non-Follow-up
Manual steering. The rudder movement is controlled by
the Port and Starboard buttons in the Pilot pop-up, or by
another NFU unit
A Auto Automatic steering, maintaining the set heading
ND NoDrift
Automatic steering, keeping the vessel on a straight bearing
line by compensating for drift
N Navigation
Automatic steering, navigating the vessel to a specific
waypoint or through a route using GPS data
W Wind * Automatic steering, maintaining the set wind angle
WN
Wind
navigation *
Automatic steering, navigating the vessel to a specific
waypoint or through a route using both wind and GPS data
* Only available if the boat type is set to Sailboat.
¼ Note: You switch the autopilot to Standby mode from any automatic mode by a
short press on the
STBY/AUTO key.
Adjust set heading / course / wind angle
Adjust set heading (Auto mode), set wind angle (Wind mode) and
set course (NoDrift mode) by:
• tapping the
Port or Starboard buttons in the autopilot pop-up,
or by
• turning the
Rotary knob.