2.3.1 Backlight ( )
On non-scanning versions of the radio the F key is replaced
with a backlighting key . Turning the backlighting on and
off requires only a single press of the key. Press and hold
the key when switching the backlight on to step through the
five lighting levels and release when the desired lighting level
is reached.
2.3.2 User Channel (P)
This function allows a user selectable personal channel to be
programmed. Select the channel, then press and hold P.
Initially the display will show the previously selected channel,
but after 2 seconds the display will show the new channel and
USE will appear on the bottom line of the display - the button
may now be released. The User channel can now be directly
accessed by pressing P.
2.2.10 User Channel (F then 16)
This function allows a user selectable personal channel to be
programmed. Select the channel, press F then press and hold
16. Initially the display will show the previously selected user
channel, but after 2 seconds the new user channel will be
shown and USE will appear on the bottom line of the display -
the button may now be released.
This channel can now be accessed by pressing F then 16.
2.3 Operation - Non-scanning Versions
In countries where scanning radios are not permitted, the sec-
ondary functions listed are not available (Fig 2.7).
The primary functions are the same with these exceptions -
RT62 & RT64
14
E04074
Fig 2.7 - Controls – non-scanning versions
To Next Page
Loading...
Need help?
General
