Sinar AP 6060 - Replacement of Batteries

IV CALIBRATION ADJUSTMENTS
12
In order to transfer one calibration to an AP analyzer, proceed as
follows:
Display Shows
1. Ensure both units are switched of f
2. Connect the calibration transfer
cable to the P2232 port on the left
hand side of the Moisture. Analyzers.
3.. Switch on both units.
5. Enter Password and press P
6. Press ~
AUTO
By this stage both units should be displaying
CO.PA (This is known as the communication mode)
On the Sending Unit
7. Pres.s Channel number e.g. 1 (This contains the
calibration curve
to be transferred to the other AP Analyzer).
8. Press’ %U
2
0. _________
On the Receiving Unit
9. Pres.s Channel number, eg 7 in which new
calibration is to be
installed.
10. Press AVER
For
4.
both
instruments:
Hold down ~
AUTO
I_HI_
i
1
CAL.
CO.PA
I
1J
Out ‘
‘I
1 I
I “~‘
I
Jo
I’
I
On the Sending Unit:
On the Receiving
Unit: