IV CALIBRATION ADJUSTMENTS
13
After 6 seconds both units will
display
The transfer is now complete.
units and remove cable.
To transfer all 7 calibrations, to
another AP Moisture Analyzer.
Both units displaying
1. On the sending unit press
%H
2
0
2. On the receiving unit press
AVER
Sending unit changes to
Receiving unit changes to
When the
transfer is
completed
both units
will display
VI HARDWARE
SECTION
VI:l SET UP
CHECKS
PASS
I
Switch off both
CO.PA
Out
In~
Out.
I in.
PASS
To check that the instrument is in good working order the
three sensors, i.e. Temperature, Weight and Capacitance
should be checked as follows:
Temperature
Pour the sample into the cell and leave for 30 seconds so
To Next Page
Loading...