18
When low-temperature dry function is turned on, directly press “▲” button or
switch the mode can quit the function.
3.9.3
Setting of Child-lock Function
Without error, under ON or OFF status of unit, press “▲” and “▼” buttons simul-
taneously for 5 seconds can enter into child-lock function, the liquid crystal screen
will display “
”; press “▲” and “▼” buttons simultaneously again for 5 seconds
can quit the child-lock function.
Under child-lock status, no response for pressing any buttons. The unit will mem-
orize the child-lock status after power failure and re-energizing the unit.
3.9.4
Setting of Memory Function
Under power-off status, press “MODE” and “▲” button simultaneously for 5 sec-
onds can turn on or turn off memory function. When memory function is set, “MEM-
ORY” displays.
If memory function has not been set, when the unit is re-energized after power
failure, the unit is power-off status. If the memory function is set in wired controller,
when the wired controller is re-energized after power failure, it will resume to the
operating status before power failure.
3.9.5
Switch between Fahrenheit and Degree Celsius
Under power-off status, press “MODE” and “▼” buttons simultaneously for 5
seconds, display board will switch between degree Celsius and Fahrenheit.
3.9.6
Inquiry of Ambient Temperature
Under power-off or power-on status, press and hold “SWING/ENTER” button for
5 seconds to enter into ambient temperature inquiry interface, then timer area
displays the ambient temperature type 01 or 02, and ambient temperature area
displays the corresponding ambient temperature of corresponding type. In which,
01 refers to outdoor ambient temperature, 02 refers to indoor ambient
temperature. Press “MODE” button can switch between type 01 and 02. Press
To Next Page
Loading...
