EA180 Series Servo Drive Users Manual
2
Safety Precautions
Safety definitions: In this Manual, safety precautions include the following two types:
Danger: Danger caused by failure to operate as required, which may lead to
serious injuries and even death;
Attention: Danger caused by failure to operate as required, which may lead to
moderate or minor injuries and equipment damage;
Please read this chapter carefully when installing, debugging and repairing this system, and be sure
to operate according to the safety precautions required herein. We bear no liability for any injury
and loss caused by illegal operation.
Safety Precautions
Before installation:
1. If it is found that the package is flooded, any parts are missing or damaged after unpacking,
please do not install the device!
2. If the mark on the outer package does not match the name of the physical product, please do
not install the device!
1. Please handle the device gently, otherwise it may be damaged!
2. Do not use damaged servo drives or servo drives with missing parts, otherwise there is a
risk of injury!
3. Do not touch any component of the control system with your hands, otherwise electrostatic
damage may be caused!
During installation:
1. Please install the device on metal or other flame retardant objects and keep it away from
combustible materials, otherwise a fire may be caused!
1. Please prevent any lead end or screw from falling into the servo drive, otherwise the device
will be damaged!
2. Please install the servo drive in a place with less vibration and no direct sunlight.
3. When the servo drive is placed in a relatively closed cabinet or space, please reserve the
installation gap to ensure the cooling effect.
When wiring:
1. The instructions in this Manual must be followed and used by professional electrical
engineers, otherwise unexpected risks will occur!
2. There must be a circuit breaker between the servo drive and the power supply, otherwise a
fire may occur!
3. Please make sure the power supply is in zero energy state before wiring, otherwise electric
shock may be caused! The servo drive must be grounded correctly according to the
standard, otherwise electric shock may be caused!
4. The grounding terminal must be grounded reliably, otherwise electric shock or a fire may be
caused.
To Next Page
Loading...
Need help?
General
