Singer 6233 - Threading the Machine and Bobbin Thread

Inserting a Bobbin
To insert a bobbin, follow the
instructions below.
. Raise presser
loot.
- < /* Turn hand wheel toward
you until needle
is in its highest position.
* Open slide
plate and remove bobbin.
/ t g ' 1. Pull 4` (10cm) of thread
from replace-
ment bobbin and insert bobbin into
case, as shown.
2. Holding bobbin
in place, guide' thread
into notch (1), and then into notch (2).
2
3. Draw several inches
of thread across
bobbin.
t~~
4. While holding thread on outside,
close
slide plate.
* Follow directions for
`Raising Bobbin
Thread" on page 13.
s'<~~~~i