Singer 6233 - Decorative and Stretch Stitches

Position the hem
under the presser
foot with the soft fold resting against
wall of the guide. Be sure the flange of
the guide is between
the soft fold and
the top
of the
hem, as
shown.
l Lower
the presser
foot and
begin
sewing making certain the straight
stitches
tall on the edge of
the hem
and the zig-zag stitches just pierce
the
soft fold
of the
work. Adjust
stitch
width if necessary. While stitching,
guide the hem edge in a straight line
and teed the soft fold evenly against
the
wall of the guide.
\If layers of fabric are pinned together,
remove pins asyou come to them. Do
not sew over pins.
Multi-Stitch Zig-Zag #8
Mending, overcasting, joining or reinforcing can all be done using the Multi-Stitch Zig-Zag.
Mending
a
Tear
.* Trim ragged edges of tear
* Cut a lining
of fabric for reinforcement.
* Bring the edges of tear
together and baste
lining to wrong side of fabric.
RECOMMENDED SETTINGS
Stitch Selection: Multi-Stitch
Zig-Zagij#n
Stitch Width: f I
Stitch Length: 1 or ower
Foot Special Purpose (j)
Needle Plate: General Purpose (A)
* Place tear, right side up, under presser
foot.
'0~ N. 7N, . * Stitch over the line of the tear, shortening
stitch length
at each
end for reinforce-
* Trim thread ends close to fabric.
* If needed, sew
overtear again.
. Trim away lining close to stitching.
22