Singer 6233 - Needle and Presser Foot Operations

Connecting the Machine
The solid state system assures constant speed as you maintain the same pressure on the
controller when sewing through various fabric thicknesses,
Unwind
the air control
hose from foot
oper-
ated
speed
controller.
/ i 5i3z ;Always be sure air hose is
not blocked.
Pressing
on the controller, you should feel
a
slight
air flow from the hose.
Plug this air hose onto the
receptacle above
power cord, at
the right end
of the machine.
Then connect
the electrical power cord plug
to your electrical outlet.
NOTE: When not
using the machine,
rewind
air hose around speed controller
/
<g-. !
for storage, as shown
Do not operate machine
without
material under the presser foot as
this may
damage
the feed and the
foot.
Running the Machine
The machine and the
sewing light are turned on
and off by the same power
switch.
1 2
t
O
To tum on machine and seWing light,
slide
L J, _ 71 _ _ Rpower switch left
to "1 " position To turn off
machine and
light, slide power switch
right
to "0,' position.
To run the machine,
press the speed con-
troller. The
harder you
press, the
faster the
C
machine
will sew.
*
To stop
the machine from sewing, remove
pressure
from speed controller,
7